Kettler Stockholm assembly instructions

By Robbins Specialties ©Copyright 2004

 

Handling


Step 16 Unfold The Table Halves


To unfold the table all you need to do is first press the top tab on the lock on the left-hand side. Then Press the bottom of the red lock on the right-hand side so the bolt is released from the notch. With the bolts on bolt sides released gradually let the top down. The legs will swing out on there own.

 

Step 17 Attach Center Support Shrouds


Parts needed
Table Assembly
From step 16
Center Support Shroud
From corrugated hardware envelope
3 Tapered screws
from hardware pack 2A
Repeat twice

Attach the center support shrouds by aligning the flanges with the holes on the center support and pus the flanges into the holes. Secure the shroud with three tapered screws from the opposite side of the center support.
Repeat this sequence on the other side of the table.

Parts needed
Table Assembly
From step 16
Center Support Shroud
From corrugated hardware envelope
3 Tapered screws
from hardware pack 2A
Repeat twice

Step 18 Fold Table Up "Handling"


To fold up the table simply lift up on red handle on the chassis guide. Pictured ":A". Then lift up form the edge of the table walk it forward into place.

 

Step 19 Net Installation


Parts needed
Table Assembly
Net
Net Height Adjustment Screws
2 Chain Adjusters
Net Tension Rods
From Hardware Pack 3

Push the net tension rods into the ends of the net. Tie the chain adjusters on to the string with about three or four inches of slack. With the slick rods through the net put the ends of the slack rods into the post the top point at the center of the top of the post and one at the bottom of the post. With the adjuster chain tied on place it on the back of the post with the post hook going thorough one of the holes to create tension. Screw the height adjustment screw into the bottom of the post directly under the hole or the tension rod.
Repeat this process on the opposite half of the table.

 

Click Here For
Parts Inventory		 Click Here For
Unpacking Instructions		 Click Here For Task 1
Center Support Assembly		 Click Here For Task 2
Chassis Assembly		 Click Here for Task 3
Handling